What a connect the pipes puzzle is
It is a path puzzle on a square grid. Some tiles hold a tap, and every colour of tap comes in a pair. You draw one pipe for each colour, from tap to tap, moving between tiles that share a side. Two pipes may never share a tile, and in the full version of the puzzle no tile may be left empty when you finish.
Playing on AllFun
AllFun Pipe Pairs has 300 boards that grow from 5×5 with four pairs to 9×9 with nine or ten, and a Daily 9×9 board. Press on a brass tap and drag; the pipe follows your finger tile by tile. Drawing through another pipe cuts that pipe back, so you can try ideas without starting over.
Lay every pipe once without picking it up again and the board earns three stars. Hint lays one complete pipe from a real solution, and Clear empties the board while keeping the taps.
The rules
- Join the two taps of each colour with a single pipe.
- Pipes run up, down, left or right, never diagonally.
- Pipes never cross and never share a tile.
- The board is solved when every pair is joined and every tile carries a pipe.
Solving step by step
1. Start where there is least room
A tap in a corner has only two neighbours, and a tap on an edge has three. Fewer choices mean fewer ways to go wrong, so pipes from these taps are often the first you can draw with confidence.
2. Hug the walls
Pipes that run around the outside of the board rarely get in anyone's way. When a pair has both taps near the edge, try routing it along the border before cutting across the middle.
3. Watch for dead ends
An empty tile with only one free neighbour is a warning. It can only be filled by a pipe that ends there, so it must belong to a tap, or a pipe must pass by in a way that lets it in. If neither can happen, the last pipe you drew is wrong.
4. Fill the leftovers
When all pairs are joined but a few tiles are still empty, look for a pipe running beside them. Bend that pipe so it takes a detour through the empty tiles; the rest of the board usually stays as it is.
Tips for big boards
- Short pairs first, but not too short. Two taps next to each other are often joined directly, though sometimes the board needs that pipe to wander.
- Keep spaces whole. Avoid splitting an empty area into small pockets that no pipe can reach.
- Count the colours in a region. An area cut off by pipes needs both taps of any colour that lives in it.
- Follow the long pipe. The pair whose taps are furthest apart usually decides the shape of the whole board.
- Plan for stars. Think a pipe through before you draw it, because picking it up again costs a move.
A short history
Puzzles about joining pairs of points with lines that must not cross appeared in newspaper puzzle columns more than a hundred years ago. A tidy grid version with numbered pairs became a favourite of logic puzzle magazines in the 1990s, and colourful versions with dots and pipes later became one of the most played puzzle types on phones.
Pipe Pairs FAQ
Can a board have more than one solution?
Yes, some can. Any way of joining all pairs and filling every tile counts as solved.
Why does a pipe disappear when I draw?
Your new pipe ran through it. Pipes never cross, so the old one is cut back to the tile before yours.
What decides the stars?
Moves. Drawing a pipe from a tap is one move; laying each pair exactly once gives three stars.
Ready for a game? AllFun Pipe Pairs is free and opens right here in your browser.
Play Pipe Pairs


